Blodgett XR8-E Manuel d'utilisateur télécharger pdf (Page 12)

Installation

Gas Connection (XR8-G only)

GAS HOSE RESTRAINT

If the oven is mounted on casters, a commercial exible

connector with a minimum of 3/4” (1.9 cm) inside diam-

eter must be used along with a quick connect device.

The restraint, supplied with the oven, must be used to limit

the movement of the unit so that no strain is placed upon

the exible connector. With the restraint fully stretched the

connector should be easy to install and quick connect.

The restraint (ie: heavy gauge cable) should be 1,000 lb.

(453 kg) test load and should be attached without damag-

ing the building. DO NOT use the gas piping or electrical

conduit for the attachment of the permanent end of the

restraint! Use anchor bolts in concrete or cement block.

On wooden walls, drive hi test wood lag screws into the

studs of the wall.

1. Mount the supplied bracket to the leg bolt below the

gas inlet.

2. Attach the clip on restraining cable to the mounting

bracket.

Restraint Cable

Bracket

Back of Oven

Figure 5

WARNING!!

If the restraint is disconnected for any reason

it must be reconnected when the oven is re-

turned to its original position.

U.S. and Canadian installations

The connector must comply with the Standard for Con-

nectors for Movable Gas Appliances, ANSI Z21.69S CSA

6.16 and a quick disconnect device that complies with the

Standard for Quick-Disconnect Devices for Use With Gas

Fuel, ANSI Z21.41S CSA 6.9. Adequate means must be

provided to limit the movement of the appliance without

depending on the connection and the quick disconnect

device or its associated piping.

General export installations

The restraint and quick connect must conform with Lo-

cal and National installation standards. Local installation

codes and/or requirements may vary. If you have any

questions regarding the proper installation and/or opera-

tion of your Blodgett oven, please contact your local dis-

tributor. If you do not have a local distributor, please call

the Blodgett Oven Company at 0011-802-658-6600.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Blodgett XR8-E Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Four Blodgett XR8-E